Alpha/Delta (Kinetic Operator) Installation and Maintenance Manual
Revision 1 - MAY 2023
101
ADJUSTING THE IES SENSITIVITY
Adjusting the IES Sensitivity
The adaptive IES (Inherent Entrapment Sensor) software monitors the average running motor current
while the gate is in motion and reverses the gate when the current exceeds an automatically self-adapting
average.
The IES display, accessed through the Installer Menu, allows you to input a number between 0 and 9. The
settings (0 through 6) allow an increasingly higher threshold (amount of headroom) above the average
current draw before tripping. For IES settings 7 through 9, the current limit is a fixed relatively high value
before the IES will be tripped. The factory setting is 2, which is adequate for most sites.
Avoid setting the IES sensitivity to
a fixed level (7 - 9 setting). The high
motor current required for the IES to
trip could cause severe injury or death
to people caught in the moving gate.
For IES settings (0 through 6) the motor current is continually being measured and the IES threshold
automatically set to trip at the average current plus the additional “headroom” provided by the IES setting
selected.
To prevent false IES trips, the software boosts the IES current threshold for one gate cycle after an IES
event, then returns to the normal sensitivity threshold.
Over time, degrading gate hardware and other site issues, such as road settling or debris on the gate rail,
can occur. As the gate hardware ages and becomes stiffer, the Kinetic motor current increases and this may
create the need to use a higher IES setting level. The higher settings should only be used on a TEMPORARY
basis until the gate, gate track, or wheels are repaired so the gate rolls smoothly with minimum resistance.
NOTE:
When wind load increases,
IES software adapts and changes the
threshold allowance. The IES threshold
automatically increases by 50% when the
temperature drops below 32
°
F (0
°C)
.
Содержание ALPHA
