24
25
9. Transporting, storing the device
• Switch off the device (See „Switching the device on, off)
• Allow the device to cool down completely
• Unplug the power supply cable from the device
• If necessary clean the device (See „Cleaning the device“)
• Lay the device and all disassembled elements into the original article packa
ging box and transport of store as specified in the technical specifications.
See technical specifications.
10.
Troubleshooting
Problem
Possible cause
Remedy
Device is
switched on,
but shows no
function
Power cord is not plugged
in or not properly inserted
Connect power cable and
power supply correctly
Micro-USB plug is not
plugged into the socket
Connect micro USB plug
correctly to the micro USB
socket of the device
Device is switched
on, blue status LED
does not shine
Power cord is not plugged
in or not properly inserted
Connect power cable and
power supply correctly
Micro-USB plug is not
plugged into the socket
Connect micro USB plug
correctly to the micro USB
socket of the device
Device is defective
Contact our service!
LED bulbs do not
light up
Device is switched off
Turn on the device
Brightness level too low
Increase the power level with
the dimming controller
Device is defective
Contact our service!
11. Maintaining the device and cleaning
WARNING
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
Cleaning
WARNING
Danger of electric shock
■
Do not bring the device into contact with moisture or water.
■
Always pull out the power supply plug before starting to clean the device.
Device
Cleaning
Housing
Use a microfiber cloth to remove light and stubborn dirt.
Illuminant
Clean off dirt with a dust brush or a dry, soft cloth
12.Accessories and options
You find the best accessories for your device in our web shop:
www.foto-walser.de
.
13. Waste disposal and protection of the environment
Dispose of the device at a legally specified collection point, such as with the
manufacturer, electronics brands or at a local disposal depot. This service is free
of charge.
14. Reference to the Declaration of Conformity
“WALSER GmbH & Co. KG. hereby declares that the remote control and integrated
radio receiver are compliant with the general requirements and all other applicable
regulations of the directive 2014/53/EU”. The Declaration of Conformity is available
from the following address: [email protected].
