Walimex Pro Operator TTL T-N, Инструкция по эксплуатации

Страница: 18 / 26

35 36
5.3 Button operation
Button Operation Function
GROUP Short press Select A/B/C group in sequence
MODE
Long press 3 s <Gr>/<Multi>
Short press
(Under <Gr> mode)
Select flash mode for each group
in sequence
1. M 1/X: set output power of TTL flash
2. M: Set output power of flash manually
(without TTL feature)
3. TTL Mode
4. Turn off the group
Short press
(Under <Multi> mode)
Select flash output / frequency / number
of flashes in sequence
SYNC/CH
Short press
(Under <Gr> mode)
Select flash sync mode in sequence
1. First curtain sync (no signal)
2. Second curtain sync
3. High-speed sync
Long press Set up channel
MODEL/AF
Short press
Set output power of modelling lamp of
A/B/C group
Long press Turn on/off AF-Assist beam
POWER
Switch to right side Switch on power
Switch to left side Switch off power
TEST Short press Test flash
Dial Rotate the dial Set parameter
6. Preparing the device for use
6.1 Installing the battery
Slide the battery cover back and open the battery compartment. According to
the positive and negative indicator on the battery compartment, insert two AA
batteries (not included) or two 1.2 V rechargeable batteries (not included).
CAUTION
If the device is going to be out of service for a long period, please remove the
batteries. When battery level is low, please replace both batteries together.
This will prevent any malfunctions.