31
32
2. Important safety information
WARNING
Danger of electric shock and fire caused by short circuit or malfunction.
A short circuit may be caused by defective cables or mositure. In case of a
short circuit the cable wires may heat up to such an extent, that the insulati-
on or even the wires themselves will melt. This may cause fire.
■
Do not operate the device with wet hands or feet.
■
Operate the equipment only in dry environments.
■
Do not use the equipment outside.
■
Make sure that cables and cable wires are free of damage. This could
be caused e.g. by exposure to heat, chemical or mechanical influences
such as chafing, buckling, tearing, rolling over or chewing pets.
■
Take care to prevent the equipment from dropping down.
If the device has dropped down on the floor have it inspected by a skilled
electrician before you switch it on again.
■
Should the equipment be damaged or defective, or if you notice a
scorching smell:
Do not operate the equipment with damaged housing. Do not open the
equipment. Do not repair the equipment yourself. Have the device only
repaired by a skilled electrician
■
Always keep your device in good condition, as specified in these
instructions for use.
3. Unpacking and checking the device
1. Carefully unpack the scope of delivery.
2. Check whether the scope of delivery is complete:
• Operator TTL T-N (Batteries not included)
3. Check whether the scope of delivery is free of damage.
NOTICE
If the scope of delivery is incomplete or damaged, please contact
In the interest of product improvements, we reserve the right to make technical
and visual changes. Illustrations may differ slightly. Not subject to identification
or labelling as per Directive 2010/30/EU. Not suitable for illumination purposes
in households. Specially developed for photo and video shooting requirements.
4. Reference to the declaration of conformity
“WALSER GmbH & Co. KG. hereby declares that the remote control and inte-
grated radio receiver are compliant with the general requirements and all other
applicable regulations of the directive 2014/53/EU”. The Declaration of Confor-
mity is available from the following address: [email protected].
5. Overview of components and control elements
5.1 Body
Operator TTL T-N
Radio Transmitter
1 Power ON/OFF
2 Test flash button
3 Select group
4 Select mode
5 Select Sync mode/Channel
6 Set modelling lamp/ Turn ON or OFF
AF-Assist beam
7 Select Dial: adjust parameter
8 OK button: save parameter
9 Radio transmission confirmation lamp
10 LCD screen
11 AF-Assist beam
9
8
1
6
10
3
4
5
2
7
11
Содержание Operator TTL T-N
Страница 26: ...51 52...
