Walimex Pro Flex LED 500 Bi Color, Инструкция по эксплуатации

Страница: 18 / 20

34 35
1. Set the ON / OFF switch on the control unit (7) to the <0> position to
switch off the unit
2. Insert a suffi ciently charged, compatible battery into the battery slot as
described in section 7.1.
3. The charging status of the inserted battery is displayed in the upper right
corner of the display.
4. The following charge states result:
4 bars 75 - 100%
3 bars 50 - 75%
2 bars 25 - 50%
1 bar 10 - 25%
No bar 10% or less
9. Transporting, storing the device
WARNING
Danger of fi re caused by hot parts of the equipment. Allow the device to
cool down completely.
• Switch off the device (See „Switching the device on, off).
• Allow the device to cool down completely.
• Unplug the power supply cable from the device.
• If necessary clean the device (See „Cleaning the device“).
• Lay the device and all disassembled elements into the original article
packaging box and transport of store as specifi ed in the technical specifi -
cations. See technical specifi cations.
10. Troubleshooting
Problem Possible cause Remedy
The device is
switched on, but
does not show
any function.
Mains cable not plugged
in or not plugged in cor-
rectly. Battery are almost
exhausted.
Plug the mains cable in
correctly.
Charge the battery.
LED lamps or
display does
not shine
The device is switched
off.
Switch on the device.
The device has not
enough power.
Increase the power of the
dimmer control.
The device is defective. Connect our service.
11. Maintaining the device and cleaning
WARNING
Danger of electric shock and danger of fi re due to short circuit.
Have the device repaired by an electrician immediately.
Cleaning
WARNING
Danger of electric shock
■ Do not bring the device into contact with moisture or water.
■ Always pull out the power supply plug before starting to clean the device.
Device Cleaning
Housing Use a microfi ber cloth to remove light and stubborn dirt.
Illuminant Clean off dirt with a dust brush or a dry, soft cloth.
NOTE
Do not clean the illuminant with water. Even slightest residues on the
illuminant can cause bursting of the illuminant.
12. Accessories and options
You fi nd optimal accessories for your device in our webshop:
www.foto-walser.de.
13. Disposal and environmental protection
Dispose of the device at a legally specifi ed collection point, such as with the
manufacturer, electronics brands or at a local disposal depot. This service is
free of charge.