Walimex Pro Flex LED 1000 Bi Color, Инструкция по эксплуатации

Страница: 15 / 20

28 29
5. Quick reference guide
Note
Detailed instructions for the following activities can be found in the relevant
sections of these instructions for use. Strictly follow the sequence of the
following activities during fi rst time use, to prevent damage to the device.
WARNING
With any action you take you should pay attention to the safety notes in the
corresponding paragraphs.
6. Preparing the device for use
The lights of the walimex pro Flex LED series can be operated by its special
construction with or without bracket. It should be noted that no control ele-
ments are installed on the light mat itself. The device is operated exclusively
via the control and power unit (7).
6.1 Fitting the light mat into the holder, mounting on a stand
For use as a classical light panel on a light stand, we fi rst recommend the ins-
tallation of the lighting mat in the X-frame holder (4). After that the preparation
of the power supply.
• Spread the braces of the X-frame (4)
• Place the light mat with the black side upwards on a clean and dry storage
space
• Slide the braces of the bracket (1) at the corners (5) of the light mat at one
of the shorter sides.
• Slide 2 of the 4 braces of the x-frame stand holder (4) into the edge holder
brackets (5) of the shorter sides of the lightning mat.
• Then, individually insert the remaining spreads into all remaining corners of
the lightning mat.
• Avoid excessive pressure and damage to the braces and light-emitting mat
corners.
• Connect the x-frame holding bracket with the bendable stand mount (6) and
secure the installed screws.
• Then insert the light mat including brackets into a suitable lamp stand or a
suitable ceiling mount (5/8 inch) spigot holder.
• Set the desired tilt angle of the bracket
• Tighten all 3 screws on the lamp holder fi rmly and securely after the fi nal
alignment of the bracket
6.2 Mounting the power adapter holder to the V-mount battery holder
You can use the built-in V-mount battery slot on the control unit (7) as a holder
for the power adapter (17). Supplied for this purpose a corresponding holder
with velcro tape (19) is included in the scope of delivery.
• Wrap this bracket included velcro straps fi rmly and tightly around the AC
adapter and close the velcro strap
• From the rear, slide the power adapter, including the mounting frame, from
the left to the right into the V-mount battery slot (15) of the control unit (7)
• A click of the battery lock (16) usually signals the save locking of the power
adapter holder
• To remove the holder again, press the battery release button (16) and remo-
ve the power adapter by pulling it out to the left
Note
Alternatively, on this devices, you can attach the power adapter units with
the supplied velcro fastening straps. Make sure that the power adapter units
are not attached too tightly. If the power adapter unit is not secured with ad-
ditional means, constant pressure will be exerted on the XLR power connec-
tion plug. This leads to wear and can damage the socket. We strongly re-
commend the usage of the ac adapter frames in the v-mount holders for
cable usage.