A3
3
Put the Wire Clip and Swivel Arm d through the Upper Pole a , adjust the preferred height
and tighten using Allen Key 5mm o . Attach the Wire Clips to the Swivel Arm d .
7
Manually swivel, tilt, and rotate the monitor for the best viewing angle.
6
Guide the cable through the Wire Clips ( k , l ) and store the Allen Keys o in the Wire Clip k .
Adjust the tilt angle using Allen Key 5mm n .
K
K
I
I
L
C
C
n1
L
K
L
K
90°
90°
90°
90°
A3
C
I
Select bolts and spacers (if needed) according to your TV/Monitor. Attach the VESA Plate to the Monitor and tighten with a screwdriver. (Screwdriver not included)
Step 4.1
Select Monitor Screws
Step 4.3a
Flat Back Monitor
Step 4.3b
Curved or Recessed Back Monitor
D
D
G
H
F
M4x12
M4x30
4
Only one screw size fits your Monitor
Step 4.2
Select Spacers ( if needed )
Hand thread screws into the
threaded inserts on the back
of your Monitor to determine
which screw (M4x12 or M4x30)
to use.
5
Put the assembled TV/Monitor onto the Swivel Arm d and tighten the VESA Plate e with
Nut h for stability.
h
d
D
C
E
Option B : Grommet Base Installation
1. Place Lower Pole a onto Grommet Base Plate m . Connect them from the bottom using M5x14
Bolt
J1
and tighten with Allen Key 3mm .
I
J1
A1
B5
I
A1
B5
J1
L
D
C
E
Notice:
Please make sure the security
nut is installed before you
rotate the monitor.
E
E
Remove the screw and washer at the top of the M10 Hand Knob N .
If the existing grommet hole comes with a plastic protector, remove it to ensure a flat surface before
installing the desk mount.
Position the Pole A on the mounting surface and connect the hand knob N through the Support
Plate Q and the grommet hole with the Pole A . Rotate the hand knob N clockwise to fasten for
stability.
Remove the screw and washer at the top of the M10 Hand Knob N .
Mark the position of the hole on your mounting surface. Drill a 3/8"(10mm) diameter hole at the
marked position through the mounting surface.
Position the Pole A on the mounting surface and connect the hand knob N through the Support
Plate Q and the self-drilled hole with the Pole A . Rotate the hand knob N clockwise to fasten
for stability.
2a. Existing Grommet Hole Installation
2b. Self-drilled Grommet Hole Installation
A1
B3
B4
B4
B4
B4
A1
A1
B3
B4
A1
A1
B4
B4
B4
B3
A1
B3
B4
B4
I
I
I
K
