M12XXL
WARNING
！
！
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
Dual Monitor Desk Mount
INSTALLATION MANUAL
1-844-SATTLER (18447288537)
www.walielectric.com
TIPOVER WARNING
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PA
RT OF MONITOR OR STAND.
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
Supplied Parts List
K (x2)
Wire Clip
Nut
E (x2)
M5x14 Bolt
J1 (x3)
M8x12 Bolt
J2 (x2)
Allen Key
I (x1)
H (x8)
M4x30 Bolt
G (x8)
M4x12 Bolt
F (x8)
M4~M6 Spacer
VESA Plate
D (x2)
C-Clamp
B1 (x1)
C-Clamp Brace
B2 (x1)
Grommet Base Plate
B5 (x1)
B3 (x1)
M10 Hand Knob
B4 (x1)
Support Plate
Swivel Arm
C (x2)
Wire Clip
L (x4)
Option A : Clamp Installation
1. Connect Lower Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f and tighten with Allen Key 3mm o .
2
Hand Knob
B2
A1
B2
J1
I
I
I
J1
B2
J2
B1
A1
B4
B3
B1
2. Remove the screw and washer at the top of the M10 Hand Knob and connect the M10 handle
, C-clamp
B1
and support plate with the screw
and washer that were just removed. Select the preferred height according to your desk thickness. Connect C-Clamp
B1
to C-Clamp Brace
B2
using M8x12
Bolt
J1
, and tighten with Allen Key 5mm I . Rotate the hand knob N clockwise to fasten for stability.
B4
B4
B1
B3
B2
B1
B4
I
J2
Lower Pole
A1 (x1)
Upper Pole
C3 (x1)
Middle Pole
B2 (x1)
1
A3
A2
A2
A1
A2
A1
I
I
Option A : 39'' Pole Installation
A1
A3
Pre-Assembly
Loosen the screws on the Lower Pole
a1
and Middle Pole
a2
with Allen key
3mm o . Connect Lower Pole
a1
, Middle Pole
a2
and Upper Pole
a3
by
tightening the screws with Allen key 3mm
o
to fix the three poles.
A1
A1
A2
I
A2
A3
I
