Waldorf SNB8200G, Руководство по эксплуатации

Страница: 19 / 24

17
NOTE:

These conversions should only be carried out by qualified persons. All connections must
be checked for leaks before re-commissioning the appliance.

For all the following conversion instructions, the side access panels have to be removed
(Remove two screws at bottom of each side panel).

All conversion details apply to both L/Hand and R/Hand burners.

For all relevant gas specifications refer to the table at the end of this section.
1. Remove the following:-
 Two side access panels.
 Main burner injectors.
2. Remove main burner injectors and replace with correct size
injectors as shown in ‘Gas Specifications’ tables at rear of this
section.
1. Remove the following:-
 Gas control knobs from front of unit.
 Two front control panels.
2. Light main burners and check flame size on Low position.
 Adjust burner gas control valve low fire adjustment screw as
shown in ‘Gas Specifications’ tables at rear of this section.
NOTE: ‘Low Fire Screw’ should be sealed with coloured paint on
completion of low fire adjustment.
3. Refit the following:-
 Two side access panels.

Two front control panels.
 Gas control knobs.
Main Burner
Injector
Low Fire
Adjustment