Waldorf RNL8510GC, Инструкция по установке и эксплуатации, Страница: 16 / 34

14
Oven - Main Burner / Thermostat
1. Ensure that the oven door is closed.
2. Turn ‘ON’ electrical power at the mains supply, the (green) power indicator light will illuminate on
the oven control panel.
3. With the pilot burner alight, depress and rotate the oven gas control knob to the 'Main Flame'
position. (This puts the gas valve in the 'Stand-By' position and control of the main burner is now
carried out through the oven thermostat control).
4. Turn the oven thermostat to the desired oven temperature setting required, this will regulate the gas
supply to the oven main burner.
5. The oven fan will start up and the oven main burner will ignite.
6. The amber heating indicator light will show that the oven main burner is ‘ON’ and the oven is
heating. When the amber heating indicator light goes out, the oven has reached the pre-selected
temperature, the burner will cycle ‘OFF’.
Oven Fan
1. The fan is operational only when the oven thermostat is set to a temperature. The fan is controlled
by a microswitch which in turn is controlled by the opening and closing of the oven door. The oven
fan is operational only with the oven door closed.
Turning the Oven to ‘Standby’ (Pilot ‘ON’ Only)
1. To turn off the oven main burner / heating, set the oven thermostat to the '0' temperature position,
this will turn the oven main burner ‘OFF’, but will leave the oven pilot burner ‘ON’.
2. In this position the pilot burner will remain alight, but the oven main burner will not operate until the
thermostat control knob is set to a temperature.
3. If oven pre-heating is required, set the thermostat control knob to temperature 190°C and allow 20
minutes before cooking in the oven to allow the oven to warm up.
Oven ‘Shut-Down’
1. To ‘Shut Down’ the oven, turn the oven thermostat to the ‘0’ position, the oven main burners will go
out.
2. Turn the gas control valve to the 'OFF' position and this will extinguish the pilot burner. (To relight
the pilot burner, refer to ‘Oven Pilot Ignition’ above).
3. Turn ‘OFF’ the electrical power at the mains supply, the (green) power indicator light will extinguish.
NOTE: If the main burner has recently been turned 'OFF', should you wish to re-light the oven, the
interlock will not allow the gas valve to be turned to the main burner position until the
interlock has reset (Approximately 1 minute). DO NOT FORCE THE GAS VALVE TO THE
MAIN BURNER POSITION UNTIL THE INTERLOCK HAS RESET, as this will damage the gas
control valve.
Operation
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation,
be noticed, the appliance requires IMMEDIATE service by a qualified service person and shall not
be used until such service is carried out.
IMPORTANT