Waldmann LAVIGO DPS 30000/840/R/G2A, Инструкция по эксплуатации

Страница: 37 / 88

37
Operation
ENG
on the sensors. For example, the upper
key on the multifunction pushbutton cor-
responds to key I on the sensors.
These instructions for use describe the
operation of the light using the multifunc-
tion pushbutton.
7.2 Switch-on and switch-off
When switching on a luminaire with LUM
CONNECT MANAGE light management,
indirect light and direct light are switched
on with a time delay. The light control is
adjusted automatically to the reflection con-
ditions of the room.
Switching the indirect light on and off
X
Press the upper switch, see Fig. 20
If you switch off the indirect light, it
does not have any direct effect on the
direct light. The light control remains
activated. LUM CONNECT MANAGE
controls the intensity of the direct light
if the intensity in the detection range
of the daylight sensor has changed.
The preset ratio of the indirect light
and direct light is tracked in the back-
ground. If the indirect light is switched
on again, the ratio is restored. The auto-
matic switch-on and -off of the luminaire
also remains activated depending on
the intensity in the room. The luminaire
switches off automatically if the inten-
sity of the daylight is sufficient.
Switching the direct light on and off
X Press the lower switch, see Fig. 20.
If you switch off the direct light, the light
control is deactivated. LUM CONNECT
MANAGE does not control the intensity
of the indirect light if the intensity in the
detection range of the daylight sensor
has changed. The automatic switch-on
and -off of the luminaire remains acti-
vated depending on the intensity in the
room. The luminaire switches off auto-
matically if the intensity of the daylight
is sufficient.
7.3 Dimming
Dimming the indirect light
X
Press the upper switch and keep it
depressed, see Fig. 20.
After about one second, the luminaire
will change its brightness.
X To change the dimming direction, press
the switch again and keep it depressed.
This will save the set brightness. The
next time the luminaire is switched on,
the brightness saved last will be set.
The ratio of the indirect light and direct
light is saved. LUM CONNECT MAN-
AGE controls the intensity of the lumi-
naire in this ratio if the intensity in the
detection range of the daylight sensor
changes.
Dimming the direct light
X Press the lower switch and keep it
depressed, see Fig. 20.
After about one second, the luminaire
will change its brightness.
X
To change the dimming direction, press
the switch again and keep it depressed.
This will save the set brightness. The
next time the luminaire is switched on,
the brightness saved last will be set.