Wahlberg Winch 10 Cable, Руководство пользователя

Страница: 3 / 46

213.805.022 3 Date: 2022-09-19
Safety Information
WARNING! Read this manual before installing, powering or servicing the product; follow the
safety precautions listed below and observe all WARNINGs in this manual and printed on the
product. If you have questions about how to operate the product, please contact you Wahlberg
Motion Design supplier or Wahlberg Motion Design.
The following symbols identify important safety information on the product and in this manual.
DANGER!
Safety hazard
WARNING!
Moving parts
can crush and
cut
DANGER!
Risk of electric
shock
WARNING!
Risk of fire
WARNING!
Hot surface
WARNING!
See manual
GENERAL PRECAUTIONS
This product is for professional use and presents risks for sever injury or death.
Always warm-up electronic equipment to room temperature before applying power.
Isolate the product from power immediately if defective or showing signs of overload. Do
not reapply power until repairs have been completed.
Do not modify the product in any way not described in this manual.
Refer any service operation not described in this manual to a qualified technician.
Install only genuine Wahlberg parts.
PROTECTION FROM INJURY
Fasten the product securely to a fixed surface, rig, or structure as described in this
manual.
Ensure that any supporting hardware can hold at least 10 times the weight of all the
devices they support.
Block access below the work area whenever installing or servicing the product.
Do not use the product to lift people or animals and do not exceed the load limits.
Do not use the product over the head of people.
PROTECTION FROM ELECTRIC SHOCK
Do not expose the product to rain or moisture.
Use an AC power source with overload and ground(earth)-fault protection.
Disconnect from AC power before servicing.
PROTECTION FROM BURNS AND FIRE
Do not operate the product if the ambient temperature (Ta) exceeds 40° C (104° F).
The exterior of the product becomes warm during use. Avoid contact by persons and
materials. Allow the product to cool for at least 10 minutes before handling.
DISPOSING OF THIS PRODUCT
Wahlberg Motion Design products are supplied in compliance with Directive 2012/19/EU of the
European Parliament and of the Council of the European Union on WEEE (Waste Electrical and
Electronic Equipment), including amendments where applicable. Help preserve the
environment! Ensure that this product is recycled at the end of its life. Your supplier can give
details of local arrangements for the disposal.