Wahlberg 50 Series, Руководство пользователя

Страница: 30 / 44

245.805.011 30 Date: 2021-12-09
DMX LED
The DMX lamp will be steady green when receiving a DMX signal.
The DMX lamp will flash green if no DMX signal is present.
Error LED
The error LED will light red if there is an error.
Reset error is done by setting DMX channel 4 to 0%.
When the Error LED lights red, there will also be an error description in the display.
Error and error codes:
Error Possible solution
Winch will not start, display
shows nothing. Check if the winch is connected to mains power.
Check if the fuse in the winch is intact
Winch 50 Series will not start,
DMX lamp is blinking. Check DMX signal
The wire is not wound up on
the drum correctly. Manually lower the wire totally off the drum, while inspecting that the wire
comes out of the winch evenly. Afterwards the wire is rolled back onto the
drum.
Reset the top position afterwards.
The winch cannot move to its position, this usually occurs when the load is high.
To solve this, go into the menu and increase the Minimum speed up.
The Roll Down does continuously not measure any movement when trying to
move. To solve this, check that the curtain has not caught onto something. If
not then go into the menu and increase the Minimum speed up.
Power failure The winch will stop at power failure. When the power is re-established, the
winch must be reset before it is ready to use.
It is advisable to set all the DMX channels on 0% before the power is re-
established.
When an error occurs, the control system shuts down the connected motor and issues a
corresponding error code. This can be queried and used to determine the cause of the error.