Wahlberg 50 Series, Руководство пользователя, Страница: 8 / 44

245.805.011 8 Date: 2021-12-09
Thank you for selecting the Winch 50 Series, a DMX controlled winch from Wahlberg Motion
Design. Before using the product for the first time, please read this manual carefully. Failure in
handling can cause injury of persons and/or damage the product.
Package content
1× Winch 50 / Winch 50 Double / Winch 50 Power and Cat5
1× powerCON NAC3FX-W-TOP female plug for power cable
1× powerCON NAC3FX-W-TOP female plug for power input to bar (246.704 Only)
1x powerCON NAC3MX-W-TOP male plug for power output from bar (246.704 Only)
1× User manual
1× Cheat sheet
Description
Winch 50 Series is a winch for stage use, mainly for use in theatres, shows and concerts.
It lifts props and small set pieces in and out of the stage sphere at a maximum load of 50 kg up
and down. The lifting height is 12.5 m. The lifting speed is between 3 cm/s and 84 cm/s.
The winch is controlled by the standard DMX signal, so a usual lighting desk can be used to control
the movement, programmed as any light.
For a limited number of winches, a standard lighting desk can be used, but when many winches
are used, more advanced desks should be used to maintain easy control of the units.
The Winch 50 Series uses 6 channels of the DMX-line, and they control the position, speed, limits,
and reset functions.
The Winch 50 Series has an advanced internal positioning system with 16 Bit, used for finding the
position desired by the operator. With a 16 Bit positioning channel (channel 1 and 2) the operator
can set the desired position, and the winch will run to this position, at the maximum speed applied
on the speed channel (channel 3).
Channel 4 is used as a safety channel. The motor will not run using DMX if channel 4 is not enabled.
With channel 5 and 6 it is possible to set the soft TOP and BOTTOM limits of the movement.
Channel 5 is also used for resetting the winch, when powering up if the position was not saved
when shut down.
On the winch it is also possible to adjust the hard TOP and BOTTOM limits and, in that way, set
the absolute span of motion regardless of any DMX control.
Multiple winches are easily daisy chained with power in-out and DMX in-out, allowing to create
advanced and dynamic movements with several winches working together in the same
installation.