WAGO-I/O-SYSTEM 750
Commissioning 137
750-8100 PFC100; 2ETH; ECO
Manual
Version 1.6.0, valid from FW Version 03.02.02(14)
7.8.1.24
“Configuration of Network Services” Page
The settings for vari
ous services are shown on the “Configuration of Network
Services” page.
Close any ports and services that you do not need!
Unauthorized persons may gain access to your automation system through open
ports.
To reduce the risk of cyber attacks and, thus, enhance your cyber security, close
all ports and services in the control components (e.g., Port 6626 for WAGO
I/O-
CHECK
, Port 2455 for CODESYS 2 and Port 11740 for
e!
COCKPIT
) not
required by your application.
Only open ports and services during commissioning and/or configuration.
Besides enabling/disabling the individual services, you can also limit the services
for each particular interface via the firewall on the “General Firewall
Configuration” page.
7.8.1.24.1
“Telnet” Group
Table 71
: WBM “Configuration of Network Services” Page – “Telnet” Group
Parameter
Explanation
Service active
Enable/disable the Telnet service here.
Click the
[Submit]
button to apply the changes. The change takes effect
immediately.
7.8.1.24.2
“FTP” Group
Table 72
: WBM “Configuration of Network Services” Page – “FTP” Group
Parameter
Explanation
Service active
Enable/disable the FTP service here.
Click the
[Submit]
button to apply the changes. The change takes effect
immediately.
7.8.1.24.3
“FTPS” Group
Table 73
: WBM “Configuration of Network Services” Page – “FTPS” Group
Parameter
Explanation
Service active
Enable/disable the FTPS service here.
Click the
[Submit]
button to apply the changes. The change takes effect
immediately.
