WAGO-SPEEDWAY 767
Parameterizing
63
767-5803 8DIO 24V DC 0,5A (8xM12)
Manual
Version 1.1.0
Pos: 30.16 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung 767- xxxx Gl obal e Parameter @ 7\mod_1265881925390_21.docx @ 50320 @ 2 @ 1
7.3
Global Settings
Table 36: Overview of parameters for the entire module
Parameter
Description
Simulation diagnostic
If the checkbox is selected, you can simulate a low voltage diagnostic.
To generate a low voltage diagnostic, one or both of the two checkboxes
"Low voltage U
LS
" and "Low voltage U
A
" must be selected.
Default setting: unselected
Low voltage U
LS
In the case of an undervoltage of the logic and sensor supply (U
LS
) or
the actuator supply (U
A
), the corresponding diagnostic is displayed here.
Low voltage U
A
Pos: 30.17 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung 767-38xx, 5xxx, 6401, 7401 Param. der F el dversorgung @ 5\mod_1249379780656_21.docx @ 40285 @ 2 @ 1
7.4
Parameters of Field Supply
Table 37: Overview of adjustable parameters for the field supply
Parameter
Description
Enable field supply
Switch on the field supply (24VDC) here.
Default setting: selected
Autorestart delay
In the event of a short circuit, the sensor supply is switched off for a
certain time. Here, enter this delay time (in 100 ms increments) after
which the sensor supply is restarted.
If the short circuit still exists, the process is repeated.
Simulation diagnostic
The simulation can be used to simulate a short circuit.
Default setting: unselected
Short circuit/overload
If simulation is deactivated, the respective error is displayed upon
emergence.
If simulation is activated, you can simulate one of the errors by selecting
the appropriate parameter.
Pos: 30.18 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
