36 System
Update
WAGO-SPEEDWAY
767
Fieldbus Coupler for CANopen
7 System
Update
Firmware update for the 767 Series components is performed via system update.
To ensure that the fieldbus node remains consistent and executable after updating
the firmware, system update must be performed for both fieldbus coupler and
connected I/O modules.
NOTICE
System update
Before updating, observe the following measures to prevent any possible damage
to the 767 system:
- The power supply must not be disconnected while updating!
- To exclude any interferences by the fieldbus, the fieldbus cable must be
disconnected before updating!
Requirement:
•
You have installed the DTM (759-370) WAGOframe
•
You have installed the DTM (759-371) WAGO service interface
•
You have installed the DTM (759-922) USB driver
•
You have installed the DTM (759-362) system update.
•
Update packages are available for the connected 767 Series components.
System Update Procedure
To perform a system update for each 767 Series component, please complete the
following steps:
1.
Read 767 components' parameters and save them on your PC.
2.
Update 767 Series components' firmware.
3.
Rewrite parameters from your PC to the 767 Series components.
4.
Set parameters to valid and finish the procedure.
