30
Connect Devices
WAGO-I/O-SYSTEM 750
750-402 4DI 24V DC 3.0ms
Manual
Version 1.1.0
Pos : 74 /All e Seri en (Allgemei ne Module)/Ü berschrif ten f ür alle Serien/Ansc hließ en/ Ger ät e ansc hließen - Ü bers chrift 1 @ 3\ mod_1234172889468_21.doc x @ 27460 @ 11 @ 1
6
Connect Devices
Pos : 75 /Serie 750 ( WAGO-I/ O-SYST EM)/ Ans chli eßen/ Leiter an C AG E C LAM P ans chli eßen - Ü berschrif t 2 und T ext @ 3\ mod_1225448660171_21.doc x @ 24928 @ 2 @ 1
6.1
Connecting a Conductor to the CAGE CLAMP
®
The WAGO CAGE CLAMP
®
connection is appropriate for solid, stranded and
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
®
connection!
Only one conductor may be connected to each CAGE CLAMP
®
connection.
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Exception:
If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to
join the wires together. The following ferrules can be used:
Length
8 mm
Nominal cross section
max.
1 mm
2
for 2 conductors with 0.5 mm
2
each
WAGO Product
216-103 or products with comparable properties.
1.
To open the CAGE CLAMP
®
insert the actuating tool into the opening
above the connection.
2.
Insert the conductor into the corresponding connection opening.
3.
To close the CAGE CLAMP
®
simply remove the tool - the conductor is
then clamped firmly in place.
Figure 10: Connecting a conductor to a CAGE CLAMP
®
Pos : 76 /D okument ation allgemei n/ Glieder ungs elemente/---Seit enwechs el--- @ 3\ mod_1221108045078_0. doc x @ 21810 @ @ 1
