WAGO 2787-2144, Руководство по эксплуатации продукта

Страница: 33 / 68

2787-2144 Connection
Product manual | Version: 1.0.0 33
Power Supply Pro 2
6 Connection
6.1 Connection
DANGER
Live parts that can be touched
High voltage can cause electric shock or burns.
1. Disconnect the product from conductors that may be live, or switch off the corre-
sponding power supplies. Protect power supplies that have been switched off
against being switched back on.
2. Verify that all parts that can be touched are actually voltage-free.
ð
Work can now be performed on the product.
Observe the maximum permissible conductor cross sections for the signal and power ca-
bles (see section
8 Technical Data [ } 18] ).
Check the appropriate operating voltage before connecting the equipment (see section
8 Type label [ } 13] ).
6.2 Connect Conductor to CAGE CLAMP®
CAGE CLAMP
®
Connectors are designed for solid, stranded and fine-stranded conduc-
tors.
Note
Only connect one conductor to each CAGE CLAMP
®
connection!
Only one conductor may be connected to each CAGE CLAMP
®
connection. Do not con-
nect more than one conductor on one single connection.
If more than one conductor must be routed to one connection, these must be connected
in an up-circuit wiring assembly, for example, using WAGO Through Terminal Blocks.
To connect the conductors, use an operating tool (see section 8 Accessories [ } 62] ) or
an appropriate screwdriver.
Perform the following steps to make the connection: