WAGNER wallperfect W 925 E, Руководство по эксплуатации

Страница: 29 / 66

GB
21
WallPerfect W 925 E
Guide the material hose close along the spray head along to the grab handle and
•
push it into the guide rail (5).
Clip the cover (11) on to the spray head.
•
Connecting the hoses (fig. 6)
Insert the control hose (1) into the grab handle
•
Insert the thin end of the black air hose (3) into the grab handle (2) (watch out for
•
marking) and fix it into position by turning it to the right.
Insert the thick end of the air hose (3) into the air-hose connection (4) on the basic
•
device (watch out for marking) and fix it into position by turning it to the right.
Connect the material hose (5) to the material hose connection socket (6) and secure
•
with securing clip.
Connect the control hose (1) to the control hose connection socket (7).
•
Connect the suction hose (8) to the suction hose connection socket (9)and secure
•
with securing clip.
Plug the attachment clip on the suction hose (10) to the edge of the paint container.
•
Push the suction hose down to the base of the paint container.
•
i
Do not push the hose too far into the paint container, as it might otherwise
bend upwards and suck in air.
Brief explanation of functionality of the W 925 E
In the W 925 E the coating material is sucked directly out of the material container by a
pump. At the nozzle, the coating material is atomised with the help of the turbine and at
the same time wrapped with a coat of air.
Multifunction switch settings (fig. 2, A)
CLEAN

The pump is ready for operation and is switched on by pulling the
trigger. The turbine is switched off.
Settings for cleaning and pre-filling the system
OFF

Pump and turbine are switched off = system is off
ON

Pump and turbine are ready for operation. The coating material is
moved and sprayed by pulling the trigger.
Operating setting
Adjusting the Material Volume
The material quantity is set depending on the characteristics of the material (viscosity)
and the working speed of the operator.
This setting can be made variably with the material flow limiter (fig. 2, B):
lower material

turn to the left
higher material

turn to the right
i We recommend starting with a low material flow setting and then gradually
adjusting this to suit needs. .