© 2001 Wagner Spray Tech. All rights reserved.
3
English
BEFORE YOU BEGIN
ONE-QUART SETUP
1. Fill the container with the material to be used.
2. Place a few drops of household oil down the intake and
return openings in the pump housing.
3. Insert the suction set into the intake opening and thread the
container securely to the sprayer.
4. Plug in the unit.
Never tip the sprayer at more than a 45° angle when using
the small container. Material could get into the motor
housing and damage the sprayer.
CAUTION
Intake
opening
Return
opening
NOTE: It is important to mix the material thoroughly
before you begin. Do not shake the material
to mix it. Always stir the material gently but
thoroughly before use.
NOTE: Remove any skin that has formed on the top
of the matierial. Do not mix the skin into the
material. The skin can break up and clog the
sprayer. Older paint may need to be strained.
SUCTION EXTENSION SETUP
1. Place a few drops of
household oil down
the intake (center)
and return (back)
openings in the
pump housing.
2. Push the dual hose
fitting into the intake
and return openings
on the bottom of the
housing. The fitting
with the ridge goes
into the return
opening.
3. Place the pump
housing locking collar
over the dual hose
fitting and turn the
locking collar clockwise
unil it locks securely.
4. Push the suction hose
set onto the intake and
return ports of the dual
hose fitting.
5. Slide the intake hose
through the container
clip. You may need to
pull the hoses slightly
apart.
6. Press the suction set hose
adapter onto the suction set.
7. Push the intake hose onto the
suction set assembly. Make
certain that the intake filter is
in place on the suction set.
8. Submerge the suction set
assembly into the material
container and attach the
container clip to the side to
hold it securely. Make certain
that the return line is inside the
container.
Read
PRIMING WITH SUCTION EXTENSION
instructions
before spraying.
Return
line
Container
clip
Intake
hose
Container
clip
Suction set
hose adapter
Suction set
Intake filter
Locking
collar
Intake
port
Intake
hose
Return
opening
Intake
opening
Dual hose
fitting
Ridge
CONTROLS AND PARTS
Suction
set
Flow knob
Cleaning brush
Handle
Suction extension
Dual hose
fitting
Motor
housing
Spray
tip
Pump
housing
Power switch
Container clip
Fluid
container
Piston
Spring
Pump housing
Locking nut
Swirl valve (2)
Spray tip
