WAGNER PROTEC 2K, Перевод оригинального руководства по эксплуатации

Страница: 64 / 132

64
PROTEC 2K
OPERATING MANUAL
VERSION 02/2016 ORDER NUMBER DOC2352824
When system with return hoses at the ball valves A and B (17 and 18): circulate via
return line
A. Guide the return hoses (43 and 44) into the product tanks A or B (no lids).
B. Fill product tank A (8) and if necessary B (9) with approx. 3 to 4 liters of fl ushing
agent each.
If the hardener is not being changed, tank B can be left empty.
C. Open ball valves A and B (17 and 18).
D. Slowly open 2K air ball valve (2). Be ready to switch from working material to air and
prevent back spray.
E. Allow fl ushing agent to run for several minutes so that the fi lter and the return
hoses are thoroughly fl ushed.
Clean the inner walls of product tank A (and if necessary B) with a separate damp
brush and fl ushing agent.
F. Close 2K spraying air ball valve (2) and ball valves A and B (17 and 18).
G. Repeat from Point 26 to this point if necessary.
Clean high-pressure fi lters
33. Points 26 to 32: empty using ball valves A + B.
34. Clean high-pressure fi lter (15) in accordance with Chapter 8.2.6. Refi t on device.
35. When system with return hoses at the ball valves A and B (17 and 18): repeat if necessary:
- Points A to F: circulate via return line.
- Points 26 to 32: empty using ball valves A + B.
Flush spray gun hoses
36. Fill product tank A (8) and if necessary B (9) with approx. 3 to 4 liters of fl ushing agent
each.
If the hardener is not being changed, tank B can be left empty.
37. Start spraying mode: Turn down red handle (12).
38. Point the spray gun without nozzle toward the grounded collecting tray and pull off .
39. Slowly open 2K air ball valve (2). Be ready to switch from working material to air and
prevent back spray.
40. Allow fl ushing agent to run for several minutes so that the spray gun hoses are thoroughly
fl ushed.
41. Close 2K air ball valve (2).
42. Relieve, close, and secure the spray gun.
43. End spraying mode: Turn red handle (12) up again.
End paint change fl ushing
44. If necessary, repeat complete fl ushing process until the fl ushing agent remains clean
and clear.
45. For system with fl ushing pump: Perform intermediate fl ushing in accordance with
Chapter 7.6.
46. Clean the outside of the system.
47. Dispose of the contents of the collection tanks according to the local regulations.
Next steps :
1. Empty 2K pump according to Chapter 8.2.4.
2. Fill 2K pump with new working material in accordance with Chapter 8.2.5.