WAGNER PROTEC 2K, Перевод оригинального руководства по эксплуатации

Страница: 61 / 132

61
PROTEC 2K
OPERATING MANUAL
VERSION 02/2016 ORDER NUMBER DOC2352824
7.6.2
INTERMEDIATE FLUSHING WITHOUT FLUSHING PUMP
1. Visual check: personal safety equipment, grounding and all devices ready to use.
Blue handle (3) at bottom. Red handle (12) at top. All circulation and return hoses are
secured and lead into the product tanks A or B.
Empty 2K pump
2. Empty 2K pump according to Chapter 8.2.4.
Flush spray gun hoses
3. Fill product tanks A and B (8 and 9) with approx. 3 to 4 liters of fl ushing agent each.
4. Close 2K air pressure regulator (1) (0 MPa; 0 bar; 0 psi).
5. Start spraying mode: Turn down red handle (12).
6. Point the spray gun without nozzle toward the grounded collecting tray and pull off .
7. Slowly open 2K air ball valve (2).
8. Slowly turn the air pressure up on the 2K air pressure regulator (1) and only until the
pump is running normally (approx. 0–0.05 MPa; 0–0.5 bar; 0–7.25 psi). Be ready to
switch from working material to air and prevent back spray.
9. Allow fl ushing agent to run for several minutes so that the 2K product is fl ushed out
of the system.
Maximize fl ow so that the entire fi lter cartridge is fl ushed.
Finish fl ushing
10. Close 2K air ball valve (2).
11. Relieve, close, and secure the spray gun.
12. End spraying mode: Turn red handle (12) up again.
13. Depressurization in accordance with Chapter 7.5.
Next steps :
- Spraying (Chapter 7.4) or
- Paint change fl ushing (Chapter 7.7) or
- at the end of work:
1. Pressure relief (Chapter 7.5)
2. Switch off device (Chapter 7.3.2)