WAGNER ProfiTech M, Оригинальное руководство по эксплуатации

Страница: 9 / 108

9
ProfiTech M
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
2
CORRECT USE
2.1
DEVICE TYPE
2.2
TYPE OF USE
The Profi Tech M controller serves to control the powder coating system's spray guns,
powder conveying device, reciprocators, and sliding table.
2.4
SAFETY PARAMETERS
2.3
USE IN POTENTIALLY EXPLOSIVE AREAS
Controller for automatic powder coating systems
The Profi Tech M controller may be used in the dust explosion zone (Zone 22) under the
following conditions (see explosion protection identifi cation in Chapter 3.1).
All connections and cable entries not needed (mains output, remote control) are
sealed with dust protection caps.
WAGNER accepts no liability for any damage arising from non-intended use.
Use the device only to work with the products recommended by WAGNER.
Operate only the device as a whole.
Do not deactivate safety fi xtures.
Use only WAGNER original spare parts and accessories.
The device may only be operated under the following conditions:
The operating staff must be trained based on this operating manual.
The safety regulations listed in this operating manual must be observed.
The operating, maintenance and repair information in this operating manual must be
observed.
The statutory requirements and accident prevention regulations standards in the
country of use must be observed.
The automatic coating system may only be used if all parameters are set and all
measurements/safety checks are carried out correctly.