Solar thermal / Collectors EN-USA_SECUSOL_TI-MA-111013-1121R800
1
TECHNICAL INFORMATION / INSTALLATION INSTRUCTIONS
Compact Solar Drainback System SECUSOL
Figure 1 SECUSOL-System
Operational Safety and Low Maintenance
When the pump is not operating, there is no solar fluid
present in the collectors. Therefore the solar fluid and any
downstream system components are protected against
detrimental effects from overheat. Unwanted gravitational
forces as well as operational faults due to air pockets are
eliminated. A service intensive membrane expansion ves-
sel, air bleeds and check valves are not required. Operati-
on with common anti-freeze solar fluid prevents potential
frost damage.
High Yield Thanks To:
●
High transparency anti reflection glass
●
Single surface absorber with selective vacuum coating
●
Solid insulation of individual components
Simplified Installation and Start-Up
●
Pre-assembled unit of storage tank, solar controller and
solar circulator, including all safety components.
●
Flexible copper double-pipe with only 12mm cross
section, for simple and time saving piping (supplied by
Wagner & Co).
●
No expansion vessel and hence no setting of pre-pres-
sure required.
●
Very simple flushing and filling
●
No venting of solar circuit required
Installation, startup and maintenance of the SECUSOL
solar thermal installation are intended to be carried out
by trained professionals only, e.g. in line with SRCC Stan-
dard OG-300 installation guidelines or NABCEP certifica-
tion. They have to be licensed, must be familiar with the
IAPMO Uniform Solar Energy Code and must conform
to applicable federal, state and local regulations, codes,
standards and meet all legal requirements related to the
installation of solar hot water systems as well as plumbing,
electrical wiring and roof works.
Content
1
Technical Information
2
1.1 Technical Data
2
1.2 Scope of Supply
8
1.3 Accessories
14
2
General Safety Notes
16
2.1 Symbols
16
2.2 Standards and Codes
16
2.3 Qualification of the Installer
17
2.4 Intended Use and Application
17
2.5 Pre Installation Notes
18
2.6 Function of the SECUSOL system
18
3
Installation
19
3.1 Preparation
19
3.2 On-Roof Installation
20
3.3 Free Standing Installation
24
3.4 General Notes about Storage Installation
29
3.5 Setting up the Storage Tank
29
3.6 Connection to Domestic Water Supply
29
3.7 Laying the Solar Circuit
31
3.8 Installing the Controller
35
4
Startup
36
4.1 DHW System
36
4.2 Backup Heating Circuit
36
4.3 Solar Circuit
36
5
Connecting the storage Insulation
38
6
Advice for the User
38
7
Maintenance and Care
39
8
Troubleshooting
40
