Wagan iOnBoost V8 Air, Руководство пользователя

Страница: 6 / 32

iOnBoost
™
V8 Air by Wagan Tech
®
4
www.wagan.com
CHARGING THE IONBOOST
This product may arrive partially charged from the manufacturer� It is recommended to
fully charge the unit immediately after purchase and before using for the first time� Prior to
charging the unit, read and understand all instructions in this manual�
In order to prolong the life of the iOnBoost, be sure to fully recharge the unit after each use and
every 6 months even if the iOnBoost has not been used.
1. Insert USB-C end of the cable into the USB-C input charge port in the jumpstarter.
2. Insert the USB end of the cable into a USB charger.
3. The Recharge Indicator icon on the LCD display will blink when the power is connected.
4. Jumpstarter is fully charged when the Recharge Indicator icon stops blinking.
Jumpstarter or inflator will not function when the unit is charging.
Do not charge in temperatures below 32°F.
JUMPSTARTER
Read the instructions before using the iOnBoost!
JUMPSTART WARNINGS
Failure to follow these instructions may cause damage or explosion�
NOTE: Cranking an engine produces an accumulation of explosive gas above and near the
vehicle battery. Before any attempt to jumpstart a vehicle battery, make sure explosive gas is
dispelled from the area. Use a cardboard or newspaper fan to wave the gases away from the
battery for a few minutes. Do not use a plastic or metal sheet—they can produce sparks and
ignite the gas.
• Jumpstart cables connected to iOnBoost are live when the Jumpstart Connection button is
activated. Never allow the clamps to touch together or contact the same piece of metal.
• Do not attempt to jumpstart your vehicle when iOnBoost is below 50% charge (observe the
Battery Percentage on the LCD display).
• Only use this jumpstarter with 12 Volt negative–grounded systems. Most US vehicles have
negative (−) battery terminals connected to the vehicle frame. (Negative – Ground). Check
the negative battery terminal connecting wire to make sure it also connects to the frame.
• Make sure the jumpstarter clamps get connected to correct polarity (red to positive battery
terminal, black to vehicle frame for negative ground systems when jumpstarting).
• Use safety glasses to protect eyes while jumpstarting a battery.
• If the engine fails to start after two 3-second cranking attempts, discontinue jumpstart
procedure. Excessive engine cranking can damage the vehicle’s starter motor. Look for
other problems that may need to be corrected or call for professional service.