WAFER GSM-DKEY REMOTE CONTROL UNIT
http://www.waferstar.com
GSM-DKEY also comes with additional 2 Input.The inputs can be used to generate alarms
when triggered.For examples,you can can connect the saftey beam output to the GSM-DKEY
Alarm1 and Alarm2 input.
WAFER GSM-DKEY PROGRAMMING
You can program the GSM-DKEY with SMS commands using your phone. It is safe to do so
because in addition to the fact that other people may not know the number of the SIM inserted in
it, we also use a Password that makes it impossible for anybody who doesn't know it to access the
system by chance.
Remember that commands must be CAPITAL LETTERS. It is PWD not pwd, CAP not Cap
etc. Don't add spaces or any other character.
Some complicated Instructions,that cann’t be programmed by the phone SMS. That would
need to use the PC software to program and inquire the status of the terminal.
The bellow wire picture is to show how to connect the cable to the PC program connector
with the Program adapter.Please connect it in the right direction with the picture.
On board,we have designed a Five pin DIP Switch
1.
MODE: When “ON” postion at MODE0 and “OFF” for MODE1
2.
ALARM:
When “ON” postion, Alarm is On
3.
ACM:
When “ON” position, ACM is On
4.
REPORT:
When “ON” position, REPORT is enable
5.
REPLY:
Not available
Only when the hardware is OFF,then can use the software to do the enable or disable
The following compand is used in the GSM-DKEY :
#PWD
:
Password
#CAP
:
Change password
#WHL
:
White List (add or remove numbers)
#GOT
:
Gate pulse time
#ACM
:
ACM is used for free control or security control
#ALARM
:
Alarm information setting
#MODE:
Relay mode
#CSQ
:
Check Signal Quality
#SCA:
Set service center address
#STATUS
:
Check status
Once you issue a command with an SMS, you will receive a confirmation SMS with OK
if everything is correct or Err if there is an Error.
