WAFE 350, Руководство пользователя

Страница: 19 / 32

WAFE 350 Operation | 19
WAFE 350 OPERATION
WAFE 350 has been designed for your maximum comfort. After installation and initial setup of
operating values by WAFE technician (according to the construction project, see section
WAFE 350 Installation / Installation and handover ), the unit needs little to no attention.
Operation modes
INTELLIGENT
MODE The unit analyses its surroundings and through optimal ventilation keeps the CO
2
levels as low
as possible.
Recommended for general use.
Requires manual activation and deactivation through my.wafe.eu.
In case CO
2
sensors are damaged unit will automatically switch to the forced Weekly mode .
WEEKLY MODE The unit provides ventilation according to its factory settings (constantly except for workdays
from 8AM till 4PM) or according to its own time schedule set up at my.wafe.eu.
Alternative to recommended general use.
Requires manual activation and deactivation through my.wafe.eu.
For other than default factory setting login to my.wafe.eu web application, activate the Weekly mode and
set your own time schedule. Remember to confirm the new setting!
HOLIDAY
[OUT] Unit is in low power mode and ventilates the house once a day.
Suitable when leaving the ventilated areas for extended periods of time.
Requires manual activation and deactivation through my.wafe.eu .
SLEEP
[STAND-BY] The unit is in low power mode, communicates over the internet (if connected) but does not
ventilate.
Turn on before unplugging from the power outlet.
Requires manual activation and deactivation through my.wafe.eu or via unit’s control panel.
Part of the transition to Sleep mode is a drying process: the unit closes its exterior flaps and the heat
exchanger and dries for 10 minutes. Unplugging the unit from the power outlet during this step might
result in residual moisture staying inside the unit.
OFF The unit is unplugged from the power outlet: it does not ventilate and does not communicate
over the internet even if connected.
Not recommended: consider using the Sleep mode instead.
Switch the unit into Sleep mode (wait for the whole drying process to finish!) and unplug the cable.
ERROR The unit does not ventilate and is awaiting the error resolution.
Automatically activated mode after encountering any errors.
After switching to Error mode , please, follow the steps in section WAFE 350 Maintenance / Problem solving .
Table 04: Operation modes of WAFE 350.