SinePower
General safety instructions
19
z
Use the device only as intended.
z
Do
not
operate the device in a damp or wet environment.
z
Maintenance and repair work may only be carried out by qualified person-
nel who are familiar with the risks involved and the relevant regulations.
2.2
Safety when installing the device
z
Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
z
Take the precautions necessary to ensure that children cannot interfere
with operation.
Dangerous situations may occur which cannot be recognised by chil-
dren!
z
Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
For installation on boats
z
If electrical devices are incorrectly installed on boats, corrosion damage
might occur. Have the inverter installed by a specialist (marine) electri-
cian.
Electrical cables
z
If cables have to be fed through metal walls or other walls with sharp edg-
es, use ducts or wire bushings to prevent damage.
z
Do not lay cables which are loose or bent next to electrically conductive
material (metal).
z
Do not pull on the cables.
z
Do not lay the 230 V mains cable and the 12/24 V DC cable in the same
duct.
z
Fasten the cables securely.
z
Lay the cables so that they cannot be tripped over or damaged.
SP160_SP350.book Seite 19 Donnerstag, 22. Februar 2007 1:51 13
