Waeco RPD190, Инструкция по установке и эксплуатации

Страница: 23 / 40

EN
RPD190, RPD218 Installing and connecting the refrigerator
23
➤ Run the drain water hose through the hole. Make sure that the hose does
not kink.
➤
Seal between the drilled hole and the drain water hose.
➤
Push the refrigerator into the recess.
➤
Fix the refrigerator in place using suitable screws (fig. 7 , page 7).
➤
Fix the lower front vent as shown in the illustrations (fig. 8 , page 7 to
fig. 9 , page 8).
6.3 Connecting the refrigerator to the power supply
Connecting the refrigerator to 12 – 24 V
A
The refrigerator can be operated with a 12 V or 24 V DC voltage supply.
For safety reasons, the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against
reversed polarity when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage
is insufficient (see table below).
NOTICE!
 To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and uninterrupted.
Therefore avoid additional switches, plugs or power strips.
 Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick
charging device.
Overvoltage can damage the electronics of the device.
12 V 24 V
Cut-off voltage
10.4 V 22.8 V
Cut-in voltage
11.7 V 24.2 V