Waeco RPD190, Инструкция по установке и эксплуатации

Страница: 22 / 40

EN
Installing and connecting the refrigerator RPD190, RPD218
22
6.2 Installing the refrigerator
Observe the following instructions when installing:

Install the refrigerator so that the hot air produced can easily flow away.
To achieve this make sure there is adequate ventilation (fig.
4 , page 5).
Key to fig. 4 , page 5
 Allow the device to rest in a vertical position for at least four hours before
you connect it to the power supply so that the oil can flow back into the
compressor.
 The installation dimensions can be found in fig. 5 , page 6.
 Keep objects clear of openings in the housing or installation structure
(such as ventilation slots, etc.).
 Condensate is produced when the refrigerator is operating normally. A
drain water hose is attached to the cooling device to drain the condensate
to the outside. If the supplied drain water hose is too short, the installer
shall replace the hose with a single length hose of the required length.
Proceed as follows to install the refrigerator:
➤ Fit the drain hose to the drain spout at the rear of the cabinet (fig.
6
1,
page 6).
➤
Drill a hole for the drain water hose (e.g. through the floor, see fig. 6 2,
page 6).
No. Description Action
1 Compressor shelf – produces
heat –
For optimum performance at high ambient temperatures:
2 Cool intake air – external vent Fit inlet vent to exterior wall
– position below compressor shelf
3 Hot waste air – external vent Fit outlet vent to exterior wall
– position above compressor shelf
For low to moderate ambient temperatures:
4 Cool intake air grille –
5 Hot waste air grille –