Waeco PerfectView M59L, Инструкция по установке и эксплуатации

Страница: 48 / 248

Installing the LCD monitor
PerfectView
48
I Note
If the monitor angle has to be readjusted, unscrew the knurled
screws (fig.
h
4 und 5, page 9).
After the adjustment of the monitor angle, screw the knurled screws
back in.
➤
Position the monitor and the attached monitor base for testing.
➤
Mark the outlines of the corners of the monitor base on the dashboard.
➤
Unscrew the monitor from the monitor base.
➤
Clean the chosen installation location before definitively mounting the
monitor base.
➤
Pull the red protective film off the monitor base.
➤
Press the monitor base firmly against the top of the dashboard.
I
Note
If necessary, use 4 x 12 mm self-tapping screws to securely fasten
the monitor base to the dashboard.
If you want to secure the monitor base with self-tapping screws
(fig.
i
, page 9):
a
Caution!
Self-tapping screws may only be fastened to steel metal with a
minimum thickness of 1.5 mm.
➤
Hold the monitor base within the outlines marked beforehand and mark
three different drilling points (fig.
i
, page 9).
➤
Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
➤
Drill Ø 3.5 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw on the monitor base with the 4 x 12 mm self-tapping screws.
➤
Mount the monitor on the monitor base as described in section „Fasten
the monitor to the monitor base (fig.
h
, page 9)“ auf Seite 47.
_M59L_EB_10s.book Seite 48 Dienstag, 22. Januar 2008 4:59 16