Waeco PerfectView CAM44, Инструкция по установке и эксплуатации

Страница: 22 / 27

EN
Fitting the camera
PerfectView CAM44
42
Attaching the camera and camera guard
A
NOTICE!
Never mount the camera without the additional camera guard. To
mount the camera guard, only use the M3 x 8 mm screws provid-
ed. Longer screws will damage the camera.
➤
Push the camera guard (fig. 8 3, page 5) over the camera in such a way
that:
– The fixing hole of the camera guard (fig.
i , page 8) is over the 3-mm
thread of the camera.
– The two other fixing holes (fig. j , page 8) are over the 4-mm threads
of the camera.
➤ Secure the camera guard with the two M3 x 6 mm screws in the hole
(fig.
i , page 8).
➤
Push the camera into the bracket (fig. j , page 8).
A
NOTICE!
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
➤
Secure the camera loosely with the four M4 x 10 mm screws in the two
other fixing holes (fig. j , page 8).
The camera is now centred.
➤
Align the camera so that the lens is at an angle of approx. 20° to the ver-
tical axis of the vehicle (fig.
k , page 8).
I
NOTE
Do not tighten the four M4 x 10 mm screws until you have aligned
the camera (see chapter “Checking the function and setting the
camera” on page 44).
To do this you must first install and connect a monitor.
_CAM44.book Seite 42 Mittwoch, 7. März 2012 10:15 10