Waeco PerfectView CAM44, Инструкция по установке и эксплуатации

Страница: 18 / 27

EN
Fitting the camera
PerfectView CAM44
38
Proceed as follows to solder two cables together:
➤
Strip the two cables (fig. c A, page 6).
➤ Place a shrink sleeve with a length of approx. 20 mm over the cable
(fig.
c B, page 6).
➤
Twist the cables together and solder them (fig. c C, page 6).
➤
Place a shrink sleeve over the soldered point and heat it briefly (fig. c D,
page 6).
8 Fitting the camera
8.1 Tools required
For installation and assembly you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Drill (fig. 1 2, page 3)

Screwdriver (fig.
1
3, page 3)

Set of ring or open-ended spanners (see fig. 1 4, page 3)
 Measuring ruler (fig. 1 5, page 3)
 Hammer (fig. 1 6, page 3)
 Centre punch (fig. 1 7, page 3)
To establish and test the electrical connection , the following tools are
required:
 Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves (optional)
To fasten the cables you may require additional cable binders.
_CAM44.book Seite 38 Mittwoch, 7. März 2012 10:15 10