Waeco PerfectView CAM44, Инструкция по установке и эксплуатации

Страница: 20 / 27

EN
Fitting the camera
PerfectView CAM44
40
 If you are not sure about the location you have chosen, ask your vehicle
manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the screws to prevent cor-
rosion.
To perform the installation, proceed as follows:
➤
Hold the camera holder at the chosen location and mark at least two dif-
ferent points for the drill holes (fig.
e , page 7).
➤
Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws (fig. f ,
page 7)
A
NOTICE!
Self-tapping screws may only be fastened to steel metal with a min-
imum thickness of 1.5 mm.
➤ Drill 4 mm diameter holes at the points you just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Stick the double-sided adhesive insulation (fig. 8 5, page 5) to the
assembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤
Screw the camera bracket on with the 5 x 25 mm self-tapping screws.
_CAM44.book Seite 40 Mittwoch, 7. März 2012 10:15 10