Waeco MagicWatch MWE850, Инструкция по установке и эксплуатации

Страница: 33 / 200

MagicWatch MWE850
Safety and installation instructions
33
When the negative terminal of the battery is disconnected, all volatile
memories in the convenience electronics lose the stored data.
z
The following data must be set again, depending on vehicle equipment:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following instructions during installation:
z
Secure the parts of the MWE850 system installed in the vehicle in such a
way that they cannot become loose under any circumstances (sudden
braking, accidents) and cause
injurie s to the occupant s of the vehicle.
z
To prevent damage, when drilling ensure that there is sufficient room for
the drill head to emerge once the hole has been made (see fig. 2, page 4).
Observe the following instructions when working with electrical parts:
z
When testing the voltage in electrical cables, only use a diode test lamp
(see fig. 1.5, page 3) or a voltmeter (see fig. 1.6, page 3).
Test lamps with an illuminant (see fig. 1.9, page 3) take up voltages which
are too high and which can damage the vehicle's electronic system.
z
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (see fig. 3,
page 4).
z
Insulate all connections.
z
Secure the cables against mechanical wear with cable binders or insulat-
ing tape, for example to existing cables.
MWE-850-4DSM.book Seite 33 Mittwoch, 23. Mai 2007 4:35 16