Waeco Magic Watch MWE-850-4DSM, Инструкция по установке и эксплуатации

Страница: 36 / 204

Installing MAGIC WATCH magic watch
36
6 Installing MAGIC WATCH
6.1 Tools required
For installation and assembly you require the following tools:
z Drill bit set (see fig. 1.1, page 3)
z Drill (see fig. 1.2, page 3)
z Screwdriver (see fig. 1.3, page 3)
z Set of ring or open-ended spanners (see fig. 1.4, page 3)
For making and testing the electrical connection the following tools are
required:
z Diode test lamp (see fig. 1.5, page 3) or Voltmeter (see fig. 1.6, page 3)
z Crimping tool (see fig. 1.7, page 3)
z Insulating tape (see fig. 1.8, page 3)
z
Cable bushing sleeves, if required
To secure the controller and the cable you may require additional screws
and cable binders.
6.2 Fitting the sensors
The sensors must be correctly aligned for the device to work.
If these point to the ground, bumps in the ground may be inter-
preted as obstacles. If they point too far up, obstacles will not be
detected.
Note the following information during installation:
z The maximum range is approximately 1.5 m.
z
So that the corners of the vehicle (indicator lights etc.) can be monitored,
the sensor should not be fitted more than 0.3 m away from them.
z The distance from the sensors to the ground must be between 40 cm and
50 cm (see fig. 10, page 6).
z
The installation location should be as flat as possible so that the cover ring
of the sensor is on the bumper.
MWE-850-4DSM.book Seite 36 Donnerstag, 7. Juli 2005 2:39 14