Wadia 7, Инструкция по эксплуатации и информации

Страница: 16 / 22

Wadia 7 CD TRANSPORT
UNPACKING
Unpack your Wadia 7 Compact Disc Transport and keep all packing materials for future use.
To avoid damaging the connectors on the rear of the product, or those on digital output
cables, never tip the product back in a way that would put stress on these connectors.
Carefully inspect the product for damage and flaws. If any are found, immediately contact
your Wadia dealer.
SET-UP AND INSTALLATION
1) Make sure that the Wadia 7 Compact Disc Transport is not plugged into the AC power
supply and is disconnected from all associated equipment.
2) Place the Wadia 7 Compact Disc Transport on a flat, stable surface and turn it onto either
of its sides (The finish of the metalwork can be protected by first placing a soft cloth or
towel down onto which the Wadia 7 can be placed).
3) Locate the transport screw on the bottom of the product, and with the tool provided, turn
the transport screw as shown on the label near the screw hole. If there is ever a need to
ship the Wadia 7, be sure to reset the transport screw to the position in which you
received it.
4) While the Wadia 7 Compact Disc Transport is still on its side, screw in the four pointed
feet into the bottoms of the four corner posts. Similarly, screw in the four pointed feet into
the bottoms of the four corner posts on the Wadia 7 Power Supply.
6) Turn the Wadia 7 Compact Disc Transport and its Power Supply upright and place them
in the desired location. Eight bases are provided to be placed underneath the four pointed
feet, for the protection of the furniture upon which the product is to be placed.
6) Connect one end of the power supply cord to the receptical on the rear of the product
and the other to a wall outlet.
7) Before turning the POWER ON / OFF switch to the ON position connect the umbilical
cord from the Wadia 7 Power Supply to the Wadia 7 Transport itself. The umbilical cord is
attached to the Power Supply, but must be connected to the Transport. There is only one
correct position with which that connection can be made, and then a turn of the outside of
the connector will lock it in place on the back of the Transport.
6) Turn the power switch on the rear of the Wadia 7 Power Supply to the ON position.
9) Connect the digital output of the Wadia 7 Compact Disc Transport to the digital input of
the associated equipment.
10) The Wadia 7 Compact Disc Transport’s Remote Control comes with its batteries installed.
When it becomes necessary to change the batteries, remove the four screws that hold
the rear cover of the Remote Control in place with a screwdriver. Insert two AA batteries
in the same direction that the original batteries are installed. Replace the Remote
Control’s rear cover.
16