![Wacker Neuson DS720 Скачать руководство пользователя страница 16](http://html1.mh-extra.com/html/wacker-neuson/ds720/ds720_operators-manual-parts-book_3229257016.webp)
1A-10
1A
OPERATION
DS720
1.14 Recommended Fuel
Use only pure diesel fuel. Close the fuel cap immediately.
It is important to maintain cleanliness to avoid problems
with the fuel injection system, and to prevent premature
clogging of the fuel filter. To avoid contamination,
DO
NOT
open the fuel line or the fuel pump or any other point
of the fuel system, not even to bleed air. The fuel pump
will bleed automatically. This applies even if the fuel tank
was run dry. If this happens, refill the fuel tank.
1.15 Before Starting
1. Read safety instructions at the beginning of this
manual.
2. Perform daily maintenance items.
3. Place rammer on loose soil or gravel.
DO NOT
start
rammer on hard surfaces such as asphalt or concrete.
1.17 Operation
Keep vibratory rammer clean and dry. Avoid no-load
strokes. Never allow the rammer to run full throttle when
forcing away material or when lifting the equipment.
CAUTION:
To prevent damage to the rammer, do not
allow the rammer to run on its side.
If the rammer should tip on its side, place the rammer in
the position shown below, then shut off the engine by
moving the throttle control lever through the detent to the
off position.
Note:
The rammer may continue to run for 5–10 seconds
after the throttle is placed to off, then the engine will stop.
1.16 To Start
1. Turn the fuel valve to the “
0
” (open) position.
2. Open the throttle control lever to the “start” position.
3. Slowly pull the recoil starter rope handle until resis-
tance is met, then release.
4. Press down on the decompression lever. (When
pulling the recoil starter rope, the decompression
lever will automatically return to initial position).
5. Quickly pull the recoil starter rope.
1.18 To Stop
Switch off the engine as follows:
CAUTION:
Do not switch off engine by means of the
decompression lever.
1. Reduce engine rpm’s and let it run for a short while.
CAUTION:
Do not switch off engine directly from full
power.
2. Shut off the engine by moving the throttle control lever
through the detent to the off position. The engine will
stop.
3. Close the fuel valve.
Note:
For short-term operation interruption, it is only
necessary to stop the engine.
1027SD77