Wacker Neuson BS Series, Руководство оператора

Страница: 11 / 50

3 Security
100_0201_si_0005.fm
11
3.11 General safety instructions – Combustion engines
The following notes must be observed:

Before starting work, check the engine to ensure there are no leaks and cracks in the fuel lines, tank
and fuel cap.

Do not operate a defective engine. Replace damaged parts immediately.

The pre-set engine speed may not be adjusted. This could lead to engine damage.

Make sure that the exhaust system of the engine is free of debris. Fire hazard!

Switch off the engine and allow it to cool before refueling.

Use the correct fuel type. The fuel may not be mixed with other liquids.

Use clean filling aids for refueling. Do not spill fuel. Immediately wipe up any spilled fuel.

The engine may not be started near spilled fuel. Explosion hazard!

When operating in partially enclosed spaces, adequate aeration must be ensured. Do not inhale
exhaust fumes. Risk of poisoning!

The engine surface and exhaust system can quickly become extremely hot. Risk of burns!
3.12 General safety instructions – Fuel, lubricants and coolants
The following notes must be observed:

Always wear safety glasses and protective gloves when handling fuel, lubricants, and coolants. Seek
medical attention, for example if you get oil or grease in your eyes.

Avoid direct skin contact with fuel, lubricants and coolants. Immediately rinse skin with soap and
water.

Do not eat or drink while working with fuel, lubricants and coolants.

Contaminated oil from dirt or water can lead to premature wear or failure of the machine.
If fuel, lubricants and coolants escape from the machine, do not operate the machine any longer and
have it repaired immediately by the Wacker Neuson contact partner.
3.13 Maintenance
The following notes must be observed:

This machine may not be maintained, repaired, adjusted or cleaned while switched on.

Adhere to maintenance intervals.

Observe the maintenance table. Non-listed work must be taken over by the service department of the
Wacker Neuson contact partner.

Immediately replace worn or damaged machine parts. Only use spare parts from Wacker Neuson.

Keep the machine clean.

Missing, damaged, or illegible safety warning labels should be replaced immediately. Safety stickers
contain important information for the protection of the operator.
Maintenance work must be performed in a clean and dry vicinity (e.g. workshop).
3.14 Personal Protective Equipment
NOTICE
This machine is outfitted with an EPA-certified engine.
Adjusting the revolutions per minute (RPM) impacts the EPA-certification and the
emissions. Settings for this engine may only be changed by a professional.
For more information, contact the manufacturer or your Wacker Neuson contact partner.
NOTICE
To prevent personal injury when handling this machine, personal protective equipment
must be worn when working on or around this machine.