Wacker Neuson BS 60-2i, Руководство оператора

Страница: 26 / 42

Operation BS 60/BS 70-2i
wc_tx000919gb.fm
26
4.6 Proper Operation
See Graphic: wc_gr002612, wc_gr005332
Keep vibratory rammer clean and dry. Avoid no-load strokes. Never
allow the rammer to run full throttle when forcing away material or
when lifting the equipment.
For optimal control, performance, and minimal hand/arm vibration,
grasp handle as shown. Hand/arm vibration (HAV) has been optimized
for this positioning. Reported HAV levels are measured at position
A
just in front of the hand position shown in conformance with EN1033
and ISO 5349.
Note: The engine is equipped with a low oil level shutoff switch. If the
engine stops running after 15-30 seconds, check the oil level in the oil
tank and add Wacker Neuson two-cycle oil or equivalent as necessary.
The engine is also equipped with an idle shut-off feature. If the engine
is operated at idle speeds for over 17-1/2 minutes, it will automatically
shut off. Allow the engine to stand for 5 seconds before attempting to
restart after an idle shut down occurrence.
NOTICE:
To prevent damage to the rammer, do not allow the rammer
to run on its side.
If the rammer should tip on its side, place the rammer in the position
shown below, then shut off the engine by moving the throttle control
lever through the detent to the off position.
wc_gr005332