Wacker Neuson 1101C, Руководство оператора

Страница: 138 / 180

5-14
BA 901/1101 en – Edition 2.1 * 91101b520.fm
Maintenance
Checking the V-belt of the air conditioning system (option)
Caution!
Excessive or insufficient tension of the V-belt can cause damage to the V-belt
or to the compressor of the air conditioning system.
☞
Always ensure that the V-belt has the correct tension!
☞
Replace V-belts with damage, cracks, cuts, etc.!
☞
Avoid contact of oil, grease or similar substances with the V-belt!
• Check as follows:
☞
Stop the engine
☞
Raise the safety bar
☞
Remove the key and carry it with you
☞
Disconnect the battery or the battery master switch
☞
Let the engine cool down
☞
Open the engine cover
☞
Carefully check V-belts 1 for damage, cracks or cuts
☞
Replace the V-belt if it touches the base of the V-belt groove or the discs of the pulley
• If the V-belt is damaged:
☞
Have the V-belt replaced by authorized personnel
☞
Press with your thumb about 100 N to check the deflection of the V-belt. A new V-belt
should have a deflection of 7 to 9 mm, a used V-belt (after about 5 minutes running
time) should have a deflection of 9 to 11 mm (see
2 ).
☞
Retighten the V-belt if necessary
Tightening the V-belt of the air conditioning system (option)
• Retighten as follows:
☞
Stop the engine
☞
Raise the safety bar
☞
Remove the key and carry it with you
☞
Disconnect the battery or the battery master switch
☞
Let the engine cool down
☞
Open the engine cover
☞
Loosen fastening screw 3
☞
Loosen lock nut 4 and turn it upward a little
☞
Screw the belt tensioner with nut 5 in the direction of arrow A , until you reach the
correct V-belt tension (fig. 101)
☞
Firmly tighten lock nut 4 again
☞
Tighten fastening screw 3
☞
Check V-belt tension again and adjust it if necessary
☞
Connect the battery or the battery master switch
☞
Close the engine cover
Fig. 100: Checking the V-belt tension of the air conditioning
system
About 8 mm
2
1
Fig. 101: Retightening the V-belt of the air conditioning
system
3
5
4
A