Wachs RS-2, Руководство пользователя

Страница: 8 / 36

RS-2
8
I. SET UP PROCEDURE (Valve Key & Socket):
1. Insert 1” drive adaptor into RS-2 drive hub, secure
with 1/4 20x5/8” SHCS. (Ref. 1)
2. Insert valve key and socket into valve. (Ref. 2)
3. Install stop collar at a comfortable operating height
to support the weight of the RS-2.
4. Mount the RS-2 on the valve key and rest on stop
collar. Connect the power source.
5. Zero the counter when valve is ready to be turned
by pressing the red reset button on the counter face.
Always use the counter to determine the number of
rotations the valve has turned.
6. Determine direction of valve rotation and which
side of RS-2 to operate from. The operator should
stand on the side of the machine which allows the
torque to PULL the machine handle away from his
body.
II. OPERATOR POSITIONING
Standing on the wrong side of the machine will allow
the handle to PUSH against the operator and can
knock him off balance or pin him against an obstacle if
torque suddenly increases. When positioned properly,
an increase in torque will PULL the handle and control
out of the operator’s hand and stop the machine (See
illustrations below).
IMPORTANT: Always refer to the manual or the valve
direction decal located on valve handle for correct
operation positions.
SECTION III
SET-UP AND OPERATION
CAUTION: The RS-2 is capable of producing up
to 800 ft./lbs. of torque to turn valves. It is very
important that proper procedure be exercised
when using the valve operating machine.
!
!
Operator should always change sides for opposite rotation
Valve Key & Socket
Valve Operator
Extension Handle
Stop Collar
1” Square Drive Adaptor
Ref. 1
Ref. 2
Valve Key Operation