8
EN
3.
Place the chamber on the sterilizer base.
For bottles:
a. Place the bottle rack inside the bottle chamber.
b. Place the bottle necks downward into the bottle posts and
place all bottle components on top of the bottles, and the bottle
nipples on the accessory tray. make sure to place all items with
the larger open ends facing down and allow space in between
for steam to travel freely.
TIP:
most bottles have a caved-in area on its bottom. shake off any
excess water to prevent water from accumulating in those indentions.
excess water may prolong the drying time, please make sure to drain
out as much water as you can.
NOTE:
due to various sizes of bottles on the market, there may be
cases where you won’t be able to fit exactly all 8 bottles on the bottle
rack.
For dinnerware:
a. Place plate rack inside the bottle chamber.
b. load the plates on the rack and utensils in the utensil holder.
For bottle nipples, breast pump parts, pacifiers and small
toys:
a. Use either the bottle or plate rack.
b. Place the items inside the chamber with the larger open ends
facing down and make sure to allow space in between for air to
travel freely.
4.
Place the accessory tray on top of the bottle chamber; the
accessory tray is necessary in order to close the lid, so always
be sure to use it.
5.
cover the lid.
6.
Plug the power cord into the outlet.
7.
choose an operation mode.
(see page 6 for control panel guide)
8.
When the chosen cycle is completed, the unit will beep 3 times
and will shut off automatically.
9.
allow to cool for 10 minutes before opening the lid. Be careful to
avoid any residual steam.
10.
Use included tongs to remove the sterilized items. Handle with
care, as the items will be hot.
