WABCO TP19039, Руководство пользователя

Страница: 14 / 34

14
Introduction
The "Port 1" and "Port 2" lettering is located on the GIO hub cable, P/N 894 600 161 2.
Refer to Figure 5 below for an example.
Fig. 5
TO ECU GIO PORT TO GIO CABLES
10. If used, connect the (optional) lift axle indicator light cable, P/N 449 827 XXX 0 to the HUB cable
plugged into GIO 2, P/N 894 600 161 2 port 2. To connect the other end of the cable to the light, the
brown wire needs to be connected to the light ground, and then the yellow wire needs to be connected
to the power side of the light. The other two wires (green, red) are not used and can be capped. Refer to
Figures 1, 2 and 3.
(The lift axle indicator light cable is not part of the kit. Please choose the appropriate length for your
application. Refer to Appendix IV.)
WABCO requires that an LED light or incandescent light of less than 1 amp is used. Ensure
the LED light has a load resistor to prevent unwanted illumination of the light.
11. The next step is to connect the TOOLBOX PLUS™ software and activate the Automatic Lift Axle function
and set the lifting and lowering pressures.
4.3 Automatic Lift Axle Activation Procedure
The following steps detail the process to activate the Automatic Lift Axle function via the TOOLBOX PLUS™
Software.
The Automatic Lift Axle function can only be enabled on premium ECUs (part numbers 400 500
350, 400 500 430).
1. Open the iABS Diagnostics from the TOOLBOX PLUS™ Main Screen by selecting the Trailer ABS
diagnostic section. Figure 6.