WABCO SMARTTRAC MM1543, Руководство по обслуживанию

Страница: 33 / 72

33
Component Replacement
When the wheel speed sensor is replaced, the sensor spring clip must also be replaced.
Installation
1. Connect the sensor cable to the chassis harness.
2. Install the fasteners used to hold the sensor cable in place.
3. Apply a WABCO-recommended lubricant to the sensor spring clip and sensor.
4. Install the sensor spring clip. Verify that the spring clip tabs are on the inboard side of the vehicle.
5. With the tabs on the inboard side, push the sensor spring clip into the bushing in the steering knuckle
until the clip stops.
6. Push the sensor completely into the sensor spring clip until it contacts the tooth wheel.
7.
Fasten the sensor cable with the first fastening point four-inches (100 mm) away from the sensor and
then every 12-inches (304.8 mm) afterwards. Correctly bundle and store any excess cable in the
sub-frame at a minimum of a 0.6-inch (15 mm) radius.
Bundle
excess
cable.
1004707a
8. Remove the blocks and safety stands.
9.
Perform a voltage output check to ensure correct installation. See the “Sensor Output Voltage Check”
section of this manual.
5.1.3 Wheel Speed Sensor Replacement — Rear Axle
Removal
1. Park the vehicle on a level surface. Apply the parking brakes. Block the front tires to prevent the
vehicle from moving.
2. Raise the rear tires off the ground. Place safety stands under the axle.
3. If the rear tire must be removed to gain access to the sensor, release the parking brake to release the
brake shoe. Remove the wheel and tire assembly from the axle.
4. Remove the sensor from the mounting block. Use a twisting motion if necessary. Do not pull on the
cable.
5. Disconnect the sensor cable from the chassis harness.
6. Remove the sensor cable from any cable clamps or clips.
7. Remove the sensor spring clip from the sensor bracket.