WABCO SMARTTRAC MM1543, Руководство по обслуживанию

Страница: 43 / 72

43
Component Replacement
10. After opening the SmartTrac™ screen, select the EOL menu and then select Bleed Procedure.
Refer to the “System Diagnostics” section of this manual for additional information.
4013019a
The bleed procedures Pump Flush, ESC Switching Sequence FRONT Axle and ESC Switching
REAR Axle will actuate the SmartTrac™ valves to ensure all air trapped inside and behind the
valves is removed.
11. Follow the on screen bleed procedure instructions as they are displayed to ensure correct bleeding
sequence. The sequence is: Pump Flush, ESC Switching Sequence REAR Axle then ESC Switching
Sequence FRONT Axle.
4013020a
12. Once the ABS and ESC valves are bled using TOOLBOX™ Software, repeat Steps 6 through 8 in this
procedure to ensure all air is removed.
13. Check the brake pedal travel and feel. If firm resistance is not felt (pedal is spongy), repeat the
bleeding procedure.
14. Replace the reservoir cap and correctly dispose of used brake fluid.
15. Remove the tire blocks.