VXI Technology, Inc.
28
CT-100B Installation
A
CRYLIC
R
ACK
M
OUNT
D
OOR
K
IT
I
NSTALLATION
An acrylic rack mount door is offered as an alternative to the aluminum rack mount door. The kit
(Option 65) provides the necessary hardware to install a 1/8” thick acrylic door in front of the rack
mounted chassis. An installation diagram is provided on the following page for ease of assembly.
This option requires that the rack mount ear kit also be installed and configured for recessed
mounting.
R
EQUIRED
T
OOLS
1. #2 Phillips Screwdriver
2. 1/8" Flat Blade Screwdriver
3. 11/32" Open Ended Wrench
P
ARTS
L
IST
QTY
ITEM
VTI P/N
2
Screw, 6-32 x 1/2" Pan Head Phillips, Sems Zinc
37-0028-050
2
Nut, Hex, 6-32, Zinc/Steel
37-0030-632
1
Latch, Vise Action, Knob Style, Black
37-0065-000
2
Hinge, Adjustable Damping, Black
37-0066-000
4
Screw, 8-32 x 3/8" Pan Head Phillips, Black Oxide
37-0079-037
1
Stop, Front Door, CT-100B
41-0133-000
1
Door, Front, CT-100, Acrylic
41-0303-000
2
Brace, Rackmount, CT-100B
41-0136-000
4
Nut, Hex, 8-32, Zinc/Steel
37-0030-832
4
Washer, Split Lock, 8-32 Zinc
37-0013-008
4
Washer, Flat 8-32, Zinc
37-0012-008
4
Screw, 8-32 x 1/2" Pan Head Phillips, Black Oxide
37-0079-050
4
Screw, 8-32 x 3/8" Flat Head Phillips, Zinc
37-0080-037
A
SSEMBLY
P
ROCEDURE
1. Lay the chassis on a protected work surface on its long side with the voltage monitor LEDs of
the chassis facing front with the power switch toward the top.
2. Locate two rack mount (cross) braces. Install one each along the front of the flanges (one on
top and one on the bottom) using four (two ea.) #8 flathead screws. The lip along the long
edge of each brace goes toward the front and pointing inside. The braces fit over the flanges
and the screws are placed from the inside going through the flange and then into the brace.
3. Locate the front door and two hinges. Install the two hinges to the front door using four 1/2”
black oxide pan head screws through the holes of the hinge with the flat washer in contact
with the door and with the split lock washer between the hex nut and the flat washer.
4. Locate the latch kit and install it into the door from the side where the hinges are mounted.
5. Locate the door latch bracket and install it on the rack mount ear opposite the end where the
hinges will be installed. Use the rack mount door installation diagram below as a reference.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
