ASSEMBLY INSTRUCTIONS
Double-check that the wood screws are not- too long for your desktop
and won't puncture the surface when screwed all the way in.
Double-check that the desk base is properly pos
i�one
d on the underside of the desktop.
Do not ov
er�g
hten screws in this step.
Ov
er�g
htening could cause damage to the components.
Connect the:
Cables (Part #12),Handset Cable (Part #10),
and the Power Cord (Part #13) to the control Box (Part #11)
as per the diagram. Use the adhesive-backed Cable Clips
(Part #15) to secure the Cables and Switch cable,
so they don't- sag.
Turn the assembled desk right side-up. With two people grab the desk BY THE DESK BASE (not the desktop)
and turn the desk right-line-up. Adjust the Glides on the Feet (Part #6 ) as needed.
STEP8
STEP9
STEP10
Page5
ASSEMBLY INSTRUCTIONS
TECHNICAL SPECIFICATIONS
Plug the Power Cord into a 110v-240v outlet.
Make sure no obstacles are in the desk's path.
Make sure the desktop is not touching any walls.
Make sure all cords are appropriate length to accommodate the change in height
Height
Range
Base
width
Travel Speed
Weight capacity
Duty Cycle
(without desktop)
(no load)
10%. Max. 2 mins on, 18 mins o
ff
So
�
start/stop
Adjustable leveling studs
4 Memory presets
STEP11
23.6 - 49.2 inch
43.3 - 70.9 inch
1.5 inch/second
320 lbs
Page6
A
tt
ach the desk base to the underside of the desktop
using eight (8) M5x16 ST Screws (Part #14):
2 per Side Bracket (Part- #3) - 4 total
1 per Crossbar End (Part #2) - 2 total
The New Design t
o fix the
control box(part#11) has never use screws,
On one Crossbar End(part#2), there is a designed Latch Pin, The back of
the control box has a matched groove, just insert the control box
to the latch pin, it c
an fix on the C
rossbar End.
Place the Programmable handset (Part #10) so
the front of the handset is flush with the front desktop
edge (or recessed up to 0.4cm). The handset may be placed
anywhere along the front edge of your desktop but we
recommend placing if toward an end so does not
interfere with your chair when seated.
Use two (2) M5x16 Screws (Part #14) to a
tt
ach the
Handset to the desktop
.
Use two (2) M5x16 Screws (Part #14) or nano adhesive tape
to a�ach the Handset to the desktop.
Latch Pin
IMPORTANT: You must keep the control box horizontal fixed on the frame,never hang it or hold on hand to avoid
error code; You must RESET the desk prior to use.
Press the "DOWN"Arrow bu�on and lower the desk to it's lowest posi�on ,and don't release for 5 seconds un�l
the LED reads "RST" ,s�ll hold on and the legs move up & down to level and stop, finally when you hear
"di" sound the reset is compleated and your table is ready to use;
www.vwindesk.com
www.vwindesk.com
