VuQube VQ4000, Руководство по эксплуатации

Страница: 7 / 28

Page 5
Fig. 6
3. Make connections as shown (Fig 6) . ALWAYS CONNECT THE POWER SUPPLY LAST.
IMPORTANT! Coax connections should be snug. HAND TIGHTEN ONLY.
CONNECT POWER SUPPLY LAST. When connecting the power supply cable to the
controller, push in the power supply cable end until it is flush against the back of the
controller.
Note: When the power supply is connected, the controller should turn on for 3 seconds and then turn off. If the
controller stays on, Press the ENTER and “-” buttons simultaneously to turn unit off.
VQ4000 Wiring Diagram
ELECTRICAL HAZARD WARNING!
The coax cable that connects the antenna unit to the controller carries a 24 volt electrical
current. Exercise extreme caution when handling this cable. Do not cut, break, or splice
this line. Do not insert or connect any devices such as splitters or any other device for any
reason. This line is not compatible with any other equipment. Damage will occur to any
device other than the antenna unit if connected to the antenna port on the controller.